Peugeot 308 Key Fob Replacement
Peugeot's 308 might be somewhat old-fashioned but it's still attractive. It's not the most luxurious vehicle in its class, but it is an enjoyable and relaxing driving experience.
Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. No matter if the issue is ongoing or continuous, the following tips should aid.
Water Damage
If you accidentally drop your key fob into an eddy, or it is soaked while kayaking, canoeing, rafting or canyoning the fob is more likely to be damaged by water. Keep your key fob in a dry container whenever you are outside or perform activities that could expose it to excessive amounts water.
It's also important to make sure the fob has completely dried out prior to opening it up and then use it again. If you detect any smells coming from the fob, like an industrial-like smell or a sour taste like windshield washer fluid, it's another sign that it's submerged in water.
A circuit that is wet can cause the battery's energy to drain or even explode. If you're able to fish your key fob 308 out of whatever body of water it was stuck in it, flip the button side down and shake out as much water as you can before opening the case. Once you have opened it, take out the battery and wipe down the circuit board using an alcohol-soaked cotton swab. 90 percent isopropyl alcohol.
Other reasons your Peugeot 308 remote entry keyless system may not function could be due to a dead coin-cell battery or receiver module issue signal interference or a malfunctioning chip. If none of the above are the reason, you may try resetting the system by disconnecting the battery with 12 volts for approximately 15 minutes.
Dead Coin Battery
Peugeot cars are equipped with a remote-start system that allows the driver to start the car from a distance while warming up or cooling down the vehicle prior to entering. This feature is very beneficial especially during the cold winter months. However, sometimes the remote start system ceases functioning due to a variety of reasons, such as the battery of a coin that is dead.
A coin-shaped battery that is located inside the key fob has a life span of two to four years, based on how often it is used and the location where it was purchased. The date of use is usually written on the package or marked in the manual.
If the key fob has stopped functioning after being exposed to clean tapwater, remove the battery and clean the electronic chip with a paper towel soaked in isopropyl ethanol. Then dry the chip completely before replacing it. If the key fob has been exposed to salty or soapy water, it may have fried the chip. It is necessary to replace it.
If you're not sure if the battery is defective you can check its voltage using a multimeter connected to both the plus and minus terminals. The voltage should range from 12-13 volts but if it is lower, the battery must be replaced. You can also reset the computer that is onboard by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first then negative cable). The engine should then start.
Faulty Receiver Module
If you're not receiving the "Key Detected" message on your dashboard, then it's possible the receiver module has discovered a problem. It's the component that transmits the signal when your key fob activates. It also acts as an alarm that stops the car from starting if it doesn't have the correct key.
This could be due to a number of factors including water damage or simply getting old. If your Peugeot 308 key fob has been exposed dirty tap water, for example the electronic chip located inside the device will be damaged. In this scenario, you'll need to take the device apart and clean it thoroughly with isopropyl alcohol or electronic cleaner. Once it's dry, you can put the battery back in and try it again.
If the issue continues to persist, it is recommended that you visit the local Peugeot expert or locksmith. They can use a diagnostic tool in order to pinpoint the problem and then fix it.
The loss of your Peugeot car keys could be an incredibly stressful experience. However, a qualified auto locksmith can address the problem in minutes. They can cut a new key and then program it into your vehicle, making sure you're ready to get to the road as quickly as possible. Click here to find a locksmith near you.
Faulty Electronic Chip
The chip in the Peugeot 308 key fob is a critical role in the remote control system. If the chip is damaged, you may be unable to start your car or receive a message saying "anti-theft". In this scenario, the only solution is to replace the key. Professional auto locksmiths are able to provide this service in the shortest time.
The chip in your Peugeot 308's key fob could fail due to various reasons, such as water damage, sweat or dirt. If your Peugeot key fob has been exposed soapy or dirty water, it needs to be cleaned right away. You can clean the electronic component with paper towels soaked with isopropyl Alcohol. The battery should be allowed to fully dry.
Sometimes keys can stop working because of radio interference. This can happen when other devices operate on the same frequencies as your Peugeot keyfob. It could be caused by bad conditions or objects within the vicinity of the vehicle. If you experience this issue, it is best to visit an Peugeot dealership.
The Peugeot Key Fob 207/308 is delicate and requires special attention. You should not drop it or throw it around. If peugeot spare key cost G28 lose it, try to find it as quickly as is possible. You can reset the on-board computer by disconnecting the battery for a few minutes. Remove the negative cable before the positive.